Now i already combine two fuselage with the monobloc and glue it with hot glue. After that setting up the elevator and rudder and make sure two pieces alignment properly with fuselage.
After 2 piece rudder and elevator joined and glued, i put a two bamboo spar at the fuselage for wing joiner
and glue it. And now the part i most hated in building R/C airplane is install carbon rod for both rudder and elevator to servo..its feel kind of lame.
Last night i only installed carbon rod to rudder control with the servo..with lack of CA glue, i had to hold on in proceeding install elevator control.
I hope i can maiden this bird at Saturday Morning ..and i hope so
Wednesday, 12 December 2012
Subscribe to:
Post Comments (Atom)
Popular Posts
-
Hello .. This time I would like to make a short review on TMnet Unifi. This article will cover about the installation, list of device, pr...
-
Finally after several weeks and days reading from RC Groups forum, i finally decided to convert my main motor to brushless one, i know its o...
-
Today i wanna replace my MIG29 profile that had crashed and smashed to ground. I wanna fly different kind of r/c jetplane so i choose a new...
-
For newer phones like the Samsung Galaxy S2 and Note the NaviSEA folder must be in the phone main memory. - 20120124 Installing Papa...
-
Continue from part 1 To build a blu-baby R/C airplane require many item and electronic such as 1. 2 Sheets foamboard - Can get from loca...
-
I am a little late to update my blog enty because I was busy preparing for my first quadcopter, I had a little experience when operating a...
-
After sometimes flying 450 size quadcopter i really satisfied with its performance, no jello and working perfect with APM flight controller....
-
I say after so many experience i had in build multirotor from KK2 , Multiwii and finally APM 2.5, i found it APM 2.5 is a most easy and n...
-
Now i already combine two fuselage with the monobloc and glue it with hot glue. After that setting up the elevator and rudder and make sure ...
No comments:
Post a Comment